Then, without shutting
off
the engine, follow these
stem:
1.
Pull out the dipstick and
wipe it with a clean rag
or paper towel.
2.
Push it ‘back
in
aa
the way, wait three seconds and
I
:then pull it back out again.
3.
Check
both
sides
ofthe
dipstick, and read the
lower level. The fluid
level must be
.in
the
cross-hatched
mea.
P
4.
If the fluid level is where
it
should be, push the
How
to
Add
Fluid:
dipstick back in all the way.
Refer
to
the Maintenance Schedule to determine what
kind of transaxle fluid to
use.
See
“Recommended
Fluids and Lubricants” in the Index.
If
the- fluid level is low, add only enough
of
the proper
fluid
to
bring the level into the cross-hatched area on the
dipstick. It doesn’t take much fluid, generally less than a
pint. D,on’t overfill. We recommend you use only fluid
labeled DEXRONB-IIE, because fluids with that label
230
I
Comments to this Manuals