NOTICE:
Horizontal aim
of
the headlamp must be done
first. Adjusting vertical
aim
first will result in
2.
Using an
E8
Torx@ socket, turn the horizontal
aiming adjustment screw
(B)
until the
“0”
(zero) on
the pointer is lined up with the center marking on the
horizontal block index plate
(C).
3.
To
adjust the vertical aim, use an
E8
Torn@
socket
and turn the vertical aiming adjustment screw
until the bubble inside the level
(D)
is centered at
“0”
(zero).
Front Parking and I’urn Signal Lamp
1.
Remove the headlamp assembly. Refer to the
removal procedure earlier in this section.
2.
Remove the rubber bulb access cover.
3.
Twist and pull the sidemarker lamp socket from the
4.
Holding the base
of
the bulb, pull the bulb from
5.
Push the new bulb into the socket.
headlamp assembly.
the socket.
B.
C.
D.
Passenger’s Side Headlamp Shown
Horizontal aim adjustment screw
Horizontal block index plate
Vertical aiming level
6.
Put the socket back into the headlamp assembly and
turn it to the right until it is secure.
7.
Replace the rubber bulb access cover.
6-37
Comments to this Manuals