Buick PARKAVENUE 1995 Owner's Manual download pdf (Page 66)

2.

Find the 16-pin diagnostic connector above the

accelerator pedal.

BLK

ASSEMBLY LINE DIAGNOSTIC

LINK (ALDL) CONNECTOR

3.

Connect

a

fuse jumper wire with alligator clips at

both ends from the program circuit (Terminal

8)

to

the

gro~~nd circuit (Terminal 4). Grounding the

program terminal erases the system memc>ry and

causes the doors to lock and unlock once. This

means the system is ready to be matched to

the

transmitter.

4.

S.

6.

7.

Keeping the program terminal gro~~nded, press the

UNLOCK

button

on

the first transmitter. The door

locks will lock and unlock again to indicate the

transmitter

is

now matched.

If

there is

110

response.

check the transmitter batteries.

If

you

do

not want

to

match

a

second transmitter. proceed to Step

6.

Still keeping the ~~"ogra~n terminal grounded, repeat

Step

4

with

the second transmitter.

If

you disconnect

the ground wire before completing this step,

only

the

first transmitter

is

matched.

If

you

make

a

mistake,

disconnect the jumper wire

and

start over

at

Step 3.

Remove the jumper wire. (Note:

The

system will

not

operate

if

the jumper wire is still connected.)

Test the operation

of

both transmitters with

the

vehicle.

If

the lock control does

not

work

as

it

should. see your

Buick dealer.

2-8

-

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 355 356

Comments to this Manuals

No comments