Buick 2010 Enclave User Manual Page 278

  • Download
  • Add to my manuals
  • Print
  • Page
    / 440
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 277
9-34 Driving and Operating
Increasing Speed While Using
Cruise Control
If the cruise control is already
engaged,
.
Press and hold the +RES button
on the steering wheel until the
desired speed is reached, then
release it.
.
To increase vehicle speed in
small increments, press the
+RES button briefly. Each time
this is done, the vehicle goes
about 1.6 km/h (1 mph) faster.
Reducing Speed While Using
Cruise Control
If the cruise control system is
already engaged,
.
Press and hold the SET button
on the steering wheel until the
lower speed desired is reached,
then release it.
.
To slow down in very small
amounts, press the SET button
briefly. Each time this is done,
the vehicle goes about 1.6 km/h
(1 mph) slower.
Passing Another Vehicle While
Using Cruise Control
Use the accelerator pedal to
increase vehicle speed. When you
take your foot off the pedal, the
vehicle will slow down to the
previously set cruise speed.
Using Cruise Control on Hills
How well the cruise control will work
on hills depends upon the vehicle
speed, load, and the steepness of
the hills. When going up steep hills,
you might have to step on the
accelerator pedal to maintain the
vehicle speed. When going
downhill, you might have to brake
or shift to a lower gear to keep the
vehicle speed down. When the
brakes are applied the cruise control
is disengaged.
Ending Cruise Control
There are three ways to end cruise
control:
.
Step lightly on the brake pedal.
.
Press the [ button.
.
Press the T button.
Erasing Speed Memory
The cruise control set speed
memory is erased when the cruise
control or the ignition is turned off.
Page view 277
1 2 ... 273 274 275 276 277 278 279 280 281 282 283 ... 439 440

Comments to this Manuals

No comments