Buick 2010 Enclave User Manual download pdf (Page 167)

Instruments and Controls 5-49

2. Hold the end of your hand-held

transmitter about 3 to 8 cm

(1 to 3 inches) away from the

Universal Home Remote buttons

while keeping the indicator

light in view. The hand-held

transmitter was supplied by the

manufacturer of your garage

door opener receiver (motor

head unit).

3. At the same time, press and

hold both the Universal Home

Remote button to be used to

control the garage door and the

hand-held transmitter button.

Do not release the Universal

Home Remote button or the

hand-held transmitter button until

Step 4 has been completed.

Some entry gates and garage

door openers may require

substitution of Step 3 with the

procedure noted in “Gate

Operator and Canadian

Programming” later in this

section.

4. The indicator light on the

Universal Home Remote will

flash slowly at first and then

rapidly after Universal Home

Remote successfully receives

the frequency signal from the

hand-held transmitter. Release

both buttons.

5. Press and hold the newly-trained

Universal Home Remote button

and observe the indicator light.

.

If the indicator light

stays on continuously, the

programming is complete

and the garage door should

move when the Universal

Home Remote button is

pressed and released.

There is no need to

continue programming

Steps 6 through 8.

.

If the Universal Home

Remote indicator light

blinks rapidly for

two seconds and then

turns to a constant light,

continue with the

programming Steps 6

through 8.

It may be helpful to have

another person assist with

the remaining steps.

6. After Steps 1 through 5 have

been completed, locate inside

the garage the garage door

opener receiver (motor-head

unit). Locate the “Learn” or

“Smart” button. The name and

color of the button may vary by

manufacturer.

1 2 ... 162 163 164 165 166 167 168 169 170 171 172 ... 439 440

Comments to this Manuals

No comments