Buick 2010 Enclave User Manual Page 168

  • Download
  • Add to my manuals
  • Print
  • Page
    / 440
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 167
5-50 Instruments and Controls
7. Firmly press and release the
Learn or Smart button. After
you press this button, you will
have 30 seconds to complete
Step 8.
8. Immediately return to the
vehicle. Firmly press and hold
the Universal Home Remote
button, selected in Step 3 to
control the garage door, for
two seconds, and then release
it. If the garage door does not
move, press and hold the
same button a second time for
two seconds, and then release
it. Again, if the door does not
move, press and hold the
same button a third time for
two seconds, and then release.
The Universal Home Remote
should now activate the
garage door.
To program the remaining two
Universal Home Remote buttons,
begin with Step 2 of Programming
the Universal Home Remote
System. Do not repeat Step 1,
as this will erase all previous
programming from the Universal
Home Remote buttons.
Gate Operator and Canadian
Programming
If you have questions or need
help programming the Universal
Home Remote System, call
1-800-355-3515 or go to
www.homelink.com.
Canadian radio-frequency laws
require transmitter signals to time
out or quit after several seconds of
transmission. This may not be long
enough for Universal Home Remote
to pick up the signal during
programming. Similarly, some U.S.
gate operators are manufactured to
time out in the same manner.
If you live in Canada, or you are
having difficulty programming a gate
operator or garage door opener by
using the Programming Universal
Home Remote procedures,
regardless of where you live,
replace Step 3 under Programming
Universal Home Remote with the
following:
Continue to press and hold the
Universal Home Remote button
while you press and release every
two seconds (cycle) the hand-held
transmitter button until the
frequency signal has been
successfully accepted by the
Universal Home Remote. The
Universal Home Remote indicator
light will flash slowly at first and then
rapidly. Proceed with Step 4 under
Programming Universal Home
Remote to complete the training
procedure.
Page view 167
1 2 ... 163 164 165 166 167 168 169 170 171 172 173 ... 439 440

Comments to this Manuals

No comments